FMP-112968-001
Page 5 of 6
Continue with “Installing the 10Base-T Card”, or “Converting from
10Base-T to T1/E1”.
Installing the 10Base-T Card
1.
Tape the two jumpers removed in step 8 to the inside of the radio
for future use. Keep the unused jumpers supplied with the kit as
spares.
2.
Install the 10Base-T PCB card onto P4/P5 (Aurora 2400), or
P10/P11 (Aurora 5800). Carefully align the sockets and press down
on all four corners of the card until it is firmly seated on the board.
3.
Secure the 10Base-T card to the board using the two screws from
the kit.
4.
Install the jumpers. See Figure 1 (Aurora 2400) or Figure 2 (Aurora
5800) for placement.
5.
Replace the cover. Insert the screws and tighten them.
6.
Connect the Data, Antenna, and Power cables.
7.
Reinstall the fuse and turn the unit on.
E1, 120 ohms
balanced
E1, 75 ohms
unbalanced
2T1
2E1, 120 ohms
balanced
2E1, 75 ohms
unbalanced
Table 2
Modem strap installation for P10 and P11
Configuration
P10
P11
1
1
1
1
1
1
1
1
1
1
