![background image](http://html2.mh-extra.com/html/icom/ic-2720h/ic-2720h_step-by-step-programming-manual_3564229001.webp)
Icom IC-2720H Step-by-Step Programming Guide
Also applies to IC-2710H (
except that the M/CALL button on the IC-2710H is called S.MW
)
Noji Ratzlaff
Set the radio to communicate with a repeater at 146.780– MHz, 100.0 Hz tone
0.
Turn on the radio and make sure it’s unlocked
(press and hold SET to unlock)
1.
Press the right M AIN to select the right
transceiver
2.
If the right display is in M em ory mode, press
the right V/M Hz to enter VFO m ode
3.
Press the right V/M Hz to select tens of M Hz,
then turn the right big knob so that the right
display reads
14
4.
Press the right V/M Hz to select M Hz, then turn
the right big knob so that the right display
reads
146
5.
Press the right V/M Hz to select kHz, then turn
the right big knob so that the right display
reads
146.780
6.
Press SET repeatedly until the low er right
show s
rt
(repeater tone)
7.
Turn the right big knob until the right display
reads
100.0
8.
Press TONE to exit SET mode, then press
TONE again to set the tone for this repeater
9.
Select the desired pow er level by pressing
LOW repeatedly
Your radio is now set to transm it as specified
Store and name the current repeater and tone settings in a memory channel
0.
Follow the procedure above to set your radio
for the frequency of your choice
1.
If the right display is in M em ory mode, press
the right V/M Hz to enter VFO m ode
2.
Press and hold the right M /CALL until you
hear a single beep
3.
Turn the right big knob until the right display
reads
37
4.
Press and hold the right M /CALL to save the
frequency and settings
Now stored in m em ory channel 37
Recall a stored memory setting
0.
Turn on the radio and make sure it’s unlocked
(press and hold SET to unlock)
1.
If the right display is not in M em ory mode,
press the right M /CALL to change to M em ory
m ode
2.
Turn the right big knob until the right display
reads your desired channel num ber
The stored channel is now ready for use