APM6800
+
/APM6801
+
Installation and Operation Manual
19
Copyright © 2008-2009, Harris Corporation
Chapter 3
Configuration and Operation
Overview
This chapter describes how to operate the APM6800
+
/APM6801
+
modules
using card-edge controls or by using CCS Navigator.
The following topics are discussed in this chapter:
•
•
“Changing Parameter Settings” on page 20
For detailed information on how to operate this product remotely, see the CCS
Pilot, CoPilot, Navigator, or NUCLEUS Network Control Panel,
LCP-3901-1U/RCP-CCS-1U manuals for Ethernet interface.
APM6800
+
/APM6801
+
modules do not support
+
Pilot Lite software;
however, you can use HTTP monitoring and control (6800
+
ETH
+
HTTP). To
use 6800
+
ETH
+
HTTP (especially if you are upgrading to 6800
+
ETH
+
HTTP
in the field), you must have the following:
•
6800
+
ETH firmware version 3.0 or higher
•
A PC connected to a LAN with a JavaScript-enabled web browser such as
Microsoft Internet Explorer 6.0
•
A FR6802
+
QXF or FR6822
+
QXFE frame installed and connected to the
LAN
•
A standard 100 Mbps 100Base-T RJ-45 Ethernet cable segment
(use a “crossover” RJ-45 cable to connect to a PC, or a normal
“straight-through” RJ-45 cable to connect to an Ethernet hub/switch)
For more information, see your
Frame Installation and Operation Manual
.
Operating Notes
When setting the control parameters on the APM6800
+
/APM6801
+
, observe
the following:
•
If you make changes to certain parameters, other related parameters may
also be affected.
Summary of Contents for APM6800+
Page 2: ......
