24. Remove front axle from accessory box
and install axle in front wheel, place
washers / spacers on both sides of axle
(See Fig 8).
25. Have second person hold up front end
using handle bars, and place front wheel
in forks being sure that the spacers are
kept on the inside of the forks, be sure
to install the wheel rotor between front
caliper brake pads (See Fig 10).
26. Tighten front axle nuts. Ensure all hard-
ware is tightened properly according to
the values in “Tools and recommended
torque values” on page 5.
27. Lower kickstand to stand up bike on its
own.
28. Center front fender and fully tighten
fender hardware. Ensure all hardware is
tightened properly according to the val-
ues in “Tools and recommended torque
values” on page 5.
29. Remove headlight from accessory box.
30. Use light mount hardware, install bolts
on light bracket, the add the long bolt
spacer to each bolt, then mount to fork
crown (See Fig 11).
31. Mount light to fork crown – tighten both
crown bolts (See Fig 12).
32. Connect light cable to power cable on
bike (See Fig 13).
Fig 13
Fig 10
Fig 11
Fig 12
34
Fig 8
Summary of Contents for SKWAD
Page 1: ...OWNER S MANUAL...
Page 36: ...harobikes com...
