HARO SKWAD, Owner'S Manual

Page: 32 / 36

1. Open Box.
2. Remove component box and set aside.
3. Remove foam inserts.
4. Remove secondary component box
5. Remove all packaging material, except
bubble wrap from seat to prevent dam-
age during assembly.
6. With a second person, lift and remove
bike from box and set upright on ground.
7. Be sure to leave foam packaging on
bottom of forks.
8. Remove battery box from bike box – take
battery out of box and plug in to fully
charge. See “Charging procedure” on
Page 10.
9. Cut tie strap holding keys to bars – place
keys in safe place.
10. Remove front wheel and fender by
cutting zip ties holding the wheel to the
bike, place wheel to the side.
11. Leave forks sitting on foam insert.
12. Remove 4 allen bolts from stem top
plate to stem - do not remove the two
pinch bolts from stem (see Fig 1).
13. Place bars into stem slot, center bars
within stem (see Fig 2).
14. Replace stem plate back onto stem and
install the 4 allen bolts, arrange the bars
into the position of your preference.
15. Once bars are positioned, tighten allen
bolts using cross pattern. Ensure all
hardware is tightened properly accord-
ing to the values in “Tools and recom-
mended torque values” on page 5. (see
Fig 3).
16. Remove packaging from front fender
17. Remove fender mounting bolt and nut
from fork bridge.
Assembly Instructions
Fig 1
Fig 3
Fig 2
32
WARNING
: Incorrect assembly, adjustments, maintenance, or use of your ebike can
cause component or performance failure, loss of control, serious injury, or death. Even
if you’re an experienced bike rider, you must read and understand the entire manual
and any documentation provided for subcomponents or accessories before riding. If
you are not sure you have the experience, skills, and tools to correctly perform adjust-
ment steps in the manual, consult a local, certified, reputable bike mechanic.
Stem pinch bolts
Stem
top
plate
bolts