Chapter 2 Installing the Encoder
Front Panel LEDs
© 2015 Harmonic Inc. All rights reserved.
20
Electra 9200, Rev O
NOTE:
During the boot sequence, do not press any key on the keypad.
The following sequence describes the display on the vacuum fluorescent display (VFD) during
a successful startup:
n
Power on
VFD line 1 =
Harmonic Logo
n
Begin loading
VFD line 1 =
Initializing
n
Configuring
VFD line 1 =
MAC Address xx:xx:xx:xx:xx
n
Booting
VFD line 1 =
BootP 1–4 (screen updates 1,2,3,4)
VFD line 2 =
Boot From Hard Drive
n
Finished
VFD line 1 =
Electra 92xx
VFD line 2 =
Multichannel Encoder
The local control panel displays messages for other types of restarts, including a system reset
and loading new software.
Messages When Resetting the Encoder
When you reset the encoder from NMX, a message on the VFD shows that the encoder has
been reset. The encoder uses the boot file on the hard drive when you reset it.
n
Reset from NMX
VFD line 1 =
Bye bye...
VFD line 2 =
n
After power cycle
VFD line 1 =
Harmonic Inc
VFD line 2 =
System Loading
n
Begin loading
VFD line 1 =
Electra 9xxx
VFD line 2 =
System Loading
n
Booting
VFD line 1 =
Electra 9xxx
VFD line 2 =
Loading xxxxxxxx.elf
n
Finished
VFD line 1 =
Electra 92xx
VFD line 2 =
Multichannel Encoder
Front Panel LEDs
The four LEDs on the front panel indicate the operational state of the encoder.
describes the front panel LEDs.
