LAH-80 Series Technical Document
- 21 -
5-3 Test run
For a test run, check the following and perform it at low speed without any load.
◇
Check items before test run
◆
The linear actuator is installed securely.
◆
The motor and end limit sensor lead wire are wired correctly.
◆
No obstacle that interferes with the movement range of the output rod exists.
◇
Check items during test run
◆
There is no abnormal vibration.
◆
The temperature of the motor part is not abnormally high.
◆
Movement of the output rod is smooth.
◆
Each of the end limit sensors operates, and operation stops.
①
The travel and feed speed of the output rod is as shown in the following formula depending on the
model.
(1) LAH-80-5020-F-PA/PB (stepping motor type)
<Driver full step>
①
Travel of the output rod (mm)
＝
②
Feed speed of the output rod(mm/s)
＝
(Note)
For driver half step, change the denominator of the formula to 500.
The rod feed speed must not exceed the maximum feed speed of 10mm/s.
250
Operating pulse count (pulse)
250
Operating pulse count (pulse/S)
