SL600 PINNACLE STAIR LIFT:
Install Manual
30SEP2020 | P/N: 76015 REV F
18
INSTALLATION
PINNACLE STAIR LIFT: SECTION 4
Figure 4-45
11. Adjust the height of the two feet using a 9/16"
open end wrench. Set them so that both rest
on the floor with the rail fully straight. The
foot furthest from the wall should be set a
little taller than the inside one to get it to sit
flat on the floor, since the Pinnacle rail
brackets intentionally lean the rail toward the
wall. See Figure 4-46.
Figure 4-46
12. Reinstall the two (2) plastic caps on the feet to
cover the threads. See Figure 4-47.
Figure 4-47
13. Carefully move the fork with your hand to
make sure it operates smoothly. Allow it to go
all the way to the floor. Confirm that both feet
sit level on the floor and the hinge-joint is
fully straight. See Figure 4-48.
Figure 4-48
Be careful not to pinch your fingers when moving
the fork.
WARNING
!
14. Follow the normal procedure for installing the
rail brackets and tighten them.
See page 9, step 8.
15. Test ride the unit a couple of times to verify
that the folding rail is operating properly.
