28
Dry Seasoned Wood Only!
Save These Instructions
Harman® • TL300 Owner's Manual_R25 • 2007 -___ • 08/15
B. General Maintenance Procedures
Ash Removal
• Frequency:
As needed / Every day or two
• By:
User
Wear Leather Gloves To Prevent Skin Burns!
Open the ash removal door by lifting upward on the latch
handle, then swing the door open. Pull the ash pan out of
the firebox, using the lip on the front of the pan. Once the
ash pan is removed from the stove, you can flip the carry
handle up for convenience.
If removing ashes while a fire is burning, close and latch the
ash door while disposing of the ashes.
DO NOT leave the appliance unattended with the ash door
open.
Door Glass
• Frequency:
As needed / Weekly
• By:
User
Whenever the view of the fire is obstructed, or weekly,
clean the glass using a soft cloth dampened with standard
household glass cleaner.
DISPOSAL OF ASHES;
Ashes should be placed in a steel container with
a tight fitting lid. The container of ashes should
be moved outdoors immediately, and placed on a
noncombustible floor or the ground, well away from
all combustible materials, pending final disposal. If the
ashes are disposed of by burial in soil or otherwise
locally dispersed, they should be retained in the closed
container until all cinders have completely cooled. Other
waste shall not be placed in this container.
Glass Retainer
screws
Glass Panel
Glass Gasket
Glass Retainers
Door Frame
Glass Specifications: 5mm X 419mm X 314mm arched.
CAUTION
!
DO NOT CLEAN GLASS WHEN HOT. Allow glass to
cool before cleaning.
Fly-ash allowed to accumulate on the glass may lead to
permanent fogging or "crazing" of the glass.
Inspect the glass and sealing gasket. Replace gasket as
needed. Do not operate the stove with a broken glass.
Replacement glass, which is ceramic glass, should be
obtained only through your Harman dealer.
To replace a broken glass; first be sure to carefully remove
the broken glass and any remaining shards or pieces. With
the door laying on a flat surface, lay the gasketed glass
panel onto the door and be sure it is properly fitted into the
channel. Lay the glass retainer clips in place near each
corner, and secure them using the 3/8" screws. Be sure to
tighten each screw equally so you don't create a pressure
point on the glass.
Do NOT Use Substitute Material for Glass Replacement.
NEVER USE ABRASIVE MATERIALS ON THE GLASS.
WARNING
!
DO NOT ABUSE GLASS BY STRIKING OR SLAMMING
THE DOOR CLOSED. THIS TYPE OF BREAKAGE IS
NOT COVERED BY THE PRODUCT WARRANTY.
