16
P P 38+ P e l l e t S t o ve
3-90-08422R34_08/13
OPERATiON
The setting above will produce continuous maximum heat
output with the distribution blower at full speed.
St o ve Tem p er a t u r e Mo d e
The setting above will produce continuous medium heat
output with the distribution blower at low speed.
CAUTiON
H OT W H iLE iN OPERATiON. K EEP CH iLDREN,
CLOTH iNG, AND FURNiTURE AW AY. CONTACT MAY
CAUSE SK iN BURNS.
St o ve Tem p er a t u r e Mo d e
In the Stove Temperature Mode, the stove can be adjusted to
the desired setting using the same temperature control dial
as is used in the Room Temperature Mode. The heat output
and fuel consumption will remain constant regardless of room
temperature. The settings from 1 to 7 on the inner ring of the
temperature dial provide for relative heat output settings with
1 being low and 7 being the maximum.
Never pull the plug to shut down the stove. This will stop the
combustion blower and smoke will escape through window
and door gaskets.
Feed Ad j u s t er K n o b
For most premium grade pellet fuels the Feed Adjuster Knob
should be set at 4. If higher ash fuels are used the setting
should be increased to 5 or 6. Also higher settings are
required if you would like to get the maximum heat output from
the stove. At the maximum burn rate (with the temperature
dial on 7/90° and the feed adjuster at 6) there should be 1" or
more of ash on the front of the burn pot. If there is less than
1" of ash, turn the feed adjuster knob down to a lower setting.
Sh u t Do w n Pr o c ed u r e
The best way to shut down the stove is to simply let it
run out of pellets. The stove will shut down automatically.
Alternatively, you can turn the Mode Selector to “off”. This
will cause the fire to gradually die down and go out. The fire
will not go out immediately and may take more than an hour
to fully shut down, depending on the burn rate.
If the stove is left to run out of fuel, you may get a 6 blink
status light. If this happens, simply reset the control board
by turning the mode selector to OFF and back ON.
