Harman PC45, Installation & Operating Manual

Page: 16 / 36

16 PC 45 Corn/Pellet Stove
3-90-02686R29_05/14
H
L
L
H
6
2
7
1
3
4
5
75°
90°
85°
80°
70°
65°
60°
55°
50°
OFF
RO
OM TEMP
STOVE TEMP
6
4
5
2
3
1
H
L
L
H
( WARNING ) HIGH VOLTAGE
Disconnect power before opening cover.
MAX.
CORN
TEST
POWER
STATUS
DISTRIBUTION
COMBUSTION
BLOWER
BLOWER
FEED MOTOR
IGNITER
6
2
7
1
3
4
5
75°
90°
85°
80°
70°
65°
60°
55°
50°
OFF
RO
OM TEMP
STOVE TEMP
AUTO
MANUAL
IGNITER
FEE
D ADJUSTER
PEL
LET ONLY
CO
RN
- PELLET
The PC45 Corn/Pellet Stove is capable of manual operation. This also allows the operator to manually
control operation during an emergency (i.e. igniter failure, when using some types of auxiliary power.)
The unit can be switched between "AUTO" and "MANUAL" at any time during operation.
NOTE: when starting the unit in the "AuTO" mode and switching to "mANuAl", wait until the
igniter light (located on the control board) comes on to confirm the ignition cycle has begun.
manual Operation
Fig. 22: Room Temperature Mode: This setting will produce a
room temperature of 70 degrees with the distribution blower at
medium speed.
Fig. 23: This setting will produce a large viewing fire without a
distribution blower operating.
6
4
5
2
3
1
H
L
L
H
( WARNING ) HIGH VOLTAGE
Disconnect power before opening cover.
MAX.
CORN
TEST
POWER
STATUS
DISTRIBUTION
COMBUSTION
BLOWER
BLOWER
FEED MOTOR
IGNITER
6
2
7
1
3
4
5
75°
90°
85°
80°
70°
65°
60°
55°
50°
OFF
RO
OM TEMP
STOVE TEMP
AUTO
MANUAL
IGNITER
FEE
D ADJUSTER
PEL
LET ONLY
CO
RN
- PELLET
manual Stove Temperature mode
Igniter Switch to "mANuAl" / room Temp mode
The fire will have to be lit with starting gel and a match, or
started automatically, see "Automatic Operation". Turn to
"Manual" position when the ignition cycle has started.
The difference between "AUTO" Room Temperature Mode
and "Manual" Room Temperature Mode is that the fire will not
go out as the room temperature goes above the control board
setting. The unit can only go to low burn and will remain there
until it runs out of fuel or until more heat is needed and the
feed rate increases. Feed rate adjustments and dial settings
are the same as "AUTO" settings.
Igniter Switch to "mANuAl" / Stove Temp mode
The advantage of this mode is to allow the operator to have
a large viewing fire without blowing extra heat into the room.
During operation, with the temperature dial set at #4 or less,
the distribution fan will not operate. Therefore, there can be
a higher burn rate (a larger viewing fire) without an excess
of hot air blowing into the room.
An example of when to use the Manual Stove Temperature
Mode is if you want to watch a large fire and the room is
already up to temperature. The Stove Temperature Mode
allows you to have a larger fire and a lower sound level,
without the distribution blower.
NOTE: during the use of this mode, if you keep increasing
the temperature dial setting to increase the fire size, the
distribution blower will automatically come on when the
ESP Temperature reaches 350
°
F, or 81% output.