12
Operation
Starting First Fire
Be sure the power cord is plugged into a 120 volt
receptacle. This can be verified by the red power light
on the control panel.
be sure there is no fuel or other combustibles in
the ash pan prior to lighting.
Fill the hopper
with pellets.
Fill the burn pot
with pellets to a level just short of
overflowing, fig. 17.
Adjust feed rate
. If this is your first fire or you are trying
different pellets, set the feed adjuster to "4", fig. 18.
This is a conservative number and will probably need
to be increased. After you know a feed rate setting that
works well, use that setting. Remember, too high of a
feed rate will waste fuel.
Turn Mode selector to "OFF" and then to "Stove
Temp"
. This will turn the combustion blower to high.
When starting a fire always turn the mode selector to
"OFF" before selecting the desired mode. This resets
the control for start-up.
Turn Temp dial to 7.
This will allow the stove to burn
at maximum for feed rate adjusting purposes.
Apply starting gel
to pellets in burn pot and
light
the gel. Close the door after lighting. At this point the
distribution and combustion lights will be on and the
feed motor light will be off. As the temperature of the fire
increases, the feed motor light will come on and pellets
will feed into the burn pot. As the stove temperature
increases the distribution blower speed will increase.
After 30 to 45 minutes it may be necessary to
readjust
the feed rate.
The feed rate should be adjusted so
there is about one inch of ash in front of the fire, fig. 20.
This is a maximum burn position and the stove may not
achieve this position under normal burn rates.
Fig. 17
Fig. 19
Fig. 20
1"
"NEVER USE GASOLINE, GASOLINE-TYPE LANTERN
FUEL, KEROSENE, CHARCOAL LIGHTER FLUID, OR
SIMILAR LIQUIDS TO START OR "FRESHEN UP " A FIRE
IN THIS HEATER. KEEP ALL SUCH LIQUIDS WELL AWAY
FROM THE HEATER WHILE IN USE".
MANuAl STArT uP
Fig. 18
Summary of Contents for P61
Page 20: ...20 Wiring Diagram...
Page 24: ......
