37
Save These Instructions
3-90-775R36_09/15
6. Igniter
Vacuum to clean.
Whenever cleaning burn pot air chamber.
To remove igniter:
• Loosen wing screws and remove cover on front of burn
pot.
•
Using a 5/16" wrench, remove the two black screws
above the cleanout. The igniter and bracket are now
free.
• Slide the insert body out of the mounting frame.
• Locate the pale blue and yellow wires entering at the
bottom of the feeder body.
• Remove wire ties as needed to loosen the igniter wires.
•
Pull the igniter and bracket out from the front until the
wire disconnects are accessible.
•
When installing igniter, reverse these steps and be sure
that the plastic coated wires are pulled all the way to the
rear of the feeder.
•
Re- tie all wires clear of all hot or moving parts.
This hole in the feeder body is where the igniter wires pass
through to the burn pot.
FEED MOTOR
This shows the igniter and bracket removed from the burn
pot. Missing in the illustration is the wires from the igniter
which run through the burn pot air chamber. Only the first
few inches of the wires are insulated for high temperatures.
These insulated wires are all that can be inside the feeder or
burn pot.