Harman Martin MAC Ultra Performance, Safety And Installation Manual

Page: 22 / 36

22
MAC Ultra Performance Safety and Installation Manual
Goboholder clips
See Figure 13. The goboholders in
both gobo wheels are held in
position by clips. When you install a
gobo in a gobo wheel, you must
make sure that the jaws of the clip
A engage in the flange in the
goboholder on both sides of the
goboholder as shown at
B .
Replacing a rotating
gobo on Gobo Wheel 1
Gobo Wheel 1, the aerial wheel, is
the wheel that is closer to the LEDs
at the back of the head. To replace
a rotating gobo on Gobo Wheel 1:
1. If you have not already removed
the top head cover, remove it as
described in “Opening the head
for access” on page 20.
2. With your fingers, rotate the
gobo that you want to remove
so that you line up a reference
point (for example, the magnet
and marking
C shown in Figure
14) on the goboholder with a
reference point in the module.
B
B
Figure 13: Goboholder clip and corresponding flange in
the goboholder
A
A
C
Figure 14: Goboholder reference mark