If you want to temporarily change the fog density, do not press
ENTER. The fog setting will go back to its stored value next time the
machine is powered up. This applies to all options.
Setting the Timer
The timer function can be utilized to set the machine’s output to automatically
cycle between an 'On' time interval and an 'Off' time interval. This mode is useful
for maintaining a low level of fog in smaller spaces.
First set the RUN TIME and OFF TIME values from the menu using the Menu
Previous / Next buttons. The timer values are displayed in the range of 0-99
seconds. Select an interval for the 'On' time; Press ENTER to store the value,
SET is displayed. Follow the same procedure for the 'Off' timer.
Next select the Fog output value from the FOG LEVEL menu and press Enter,
SET is displayed.
Finally select the TIMER option from the RUN MODE menu, press ENTER, SET
is displayed. The timer will cycle continuously until the run menu option is
changed.
Using the Settings menu
Options such as the DMX start address, display brightness, Host/Client linking,
priming, factory reset and temperature control (ZR45 only) are found in the
SETTINGS menu.
Use the Previous / Next buttons to select the SETTINGS option.
Press the Enter button to go to the SETTINGS menu.
To return to the main menu, use the Previous / Next buttons to select EXIT and
press ENTER.
Setting the DMX start address
Use the Previous / Next buttons to select the DMX option from the SETTINGS
menu.
Use the Up/Down buttons to set the DMX start address from 001 to 511. If you
hold down the button the address will count up or down more quickly.
Press the ENTER button to store the address setting.
The machine will automatically respond to a DMX controller whenever it is
connected.
When using in a DMX system ensure the LINK MODE menu is set to RECEIVE
(the default setting) to avoid causing DMX errors to other devices on the system.
Alternatively, the DMX start address can be set via RDM.
Display back light setting
You can set the brightness of the display backlight using the BACK LIGHT
option.
Use the Previous / Next buttons to select the BACK LIGHT option from the
SETTINGS menu.
Use the Up/Down buttons to change the option to LOW, NORM or HIGH.
Press the ENTER button to store the setting.
