Harman Martin ELP PAR, User Manual, Page: 41 / 52

Martin ® ELP PAR User Guide 41
SAVE
Save current
custom calibration
settings.
Important! See
note below
SAVE SETTING SAVE
Replace factory
default calibration
settings with
custom values
or zero values.
Important! See
note below
CLEAR ALL
VALUES
RESTORE
Reset all calibration
values to zero.
Important! See
note below
Important note
•
LOAD DEFAULTS → SAVE stores any custom calibration values that
you have created in the CALIBRATION menu. The fixture will keep using
these values even when the fixture power is cycled off and on.
•
LOAD DEFAULTS → LOAD loads the original factory default cal ibration
values (unless these have been overwritten or erased – see below)
•
CLEAR ALL VALUES → RESTORE erases all calibration settings – both
custom settings and the original factory settings. Important! If you use
this command you will need to fully recalibrate the fixture.
•
Important! SAVE SETTING → SAVE permanently overwrites the
original factory settings with either the custom settings created
using LOAD DEFAULTS → SAVE or the zero values created using
CLEAR ALL VALUES → RESTORE. The SAVE SETTING → SAVE
command should normally be used by Martin Service only!