fig.7.1 - Inserts
WAGO CONNECTORS
All other Intellivox connections are made via the four on-
board WAGO Type 231 multi-pin connectors. These are:
• Audio (6-way male)
• Network (5-way male)
• Ambient noise mic/Ext. temp. sensor (5-way female)
• Failure detection/Fan control (5-way female)
One 5-way and one 6-way mating female connec-
tor is supplied with every unit for the network and
audio connections. 5-way mating male connectors for
the other two sockets are available separately from JBL if
required (see page 22), but will be shipped with the unit
if specified at the time of order.
To wire the WAGO Type 231 connectors, proceed as
follows:
1) Prepare the cable; strip back approximately 8-9
mm (0.35”) of the insulation of each core.
2) Refer to the table below: select the appropriate PVC in-
sert for the wire size. If the wire is too big for the largest
size insert, the inserts can be ignored and the wire
connected directly (next step). Insert the wire into the
insert so that the bare end goes through the hole
but the insulated portion does not.
JBL Intellivox Installation Manual
3) Using the wire insertion tool supplied as shown below,
open the clamp contact in the connector shell by pressing
inwards towards the shell.
fig.7.2 - Using the WAGO insertion tool
4) Insert the stripped wire, with or without a PVC insert,
into the hole as shown. If using an insert, ensure that it is
fully seated. Release the wire insertion tool, and check that
the wire is secured. Repeat from Step 2 for all other cores.
10
202007/IvxIM_v2.3
WIRE SIZE
INSERT COLOUR
0.08 to 0.2 mm
2
White
0.25 to 0.5 mm
2
Light grey
0.75 to 1.0 mm
2
Dark grey
