29
3-90-233R24_11/13
4.
If Starting After an Empty hopper, Turn Feed Adjuster
to “TEST”
(for one 60 second cycle). This will charge
pellets into the auger tube and also allow you to check
the motors for operation.
NOTE: The auger motor will
not operate with any of the doors or hopper lid open.
5.
Turn Feed Adjuster to #5.
If this is your first fire or you are
trying a new fuel, set the feed adjuster to #5. This setting
works well with the average wood pellets, but may need
adjusted for your particular fuel. After you know a feed
rate setting that works well for your application, stick with
that setting.
NOTE:
You know your feed rate is too high when: The
overheat safety feature is energized each time the heating
zone demand turns off during a high burn. OR, If unburned
or partially burned pellets are found in the ash pan. (this may
also indicate a need for scraping the burn pot)
If you need to keep the feed adjuster on it’s maximum setting,
your unit is under-sized for the heating system. Continuous
operation at maximum burn rate may cause pre-mature failure
of the firebox baffles.
Note: The firebox baffles (#1-10-232052) are considered
to be a consumable item, and are therefore not covered
by the product warranty.
6.
Flip the Igniter Switch up
into the “AUTO” position.
due to low water temperature, the initial start will be
a longer process than when the water temperature is
closer to the minimum setting.
7.
Turn the mAx. TEmP. dial
on the control board to the
desired temperature. This setting must always be at least
5° F. higher than the MIN. TEMP. setting.
Operation
WATER TEMPERATURE
MAX. TEMP.
MIN. TEMP.
WARNING
!
hOT whIlE IN OPErATION. dO NOT TOuCh. kEEP
ChIldrEN, ClOThINg, ANd FurNITurE AwAY.
CONTACT mAY CAuSE SkIN burNS.
