28
Maintenance
A qualified service agency should conduct an annual inspection and maintenance of your FireLuxe including
the overall installation and venting to keep it running safely. The following procedures should be performed only
by a qualified service person. The gas supply should be turned off and the stove should be completely cool
whenever a maintenance procedure is performed. All parts of the appliance that are removed for servicing must
be replaced prior to operation.
REPLACING THE GLASS
The glass mounting system consists of the glass panel, special glass gasket and the metal glass frame.
Should the glass need to be replaced, you must use the glass replacement parts that can be obtained from
your authorized Harman dealer. When replacing the glass, you must use a new glass gasket. Use the following
procedure and refer to the illustrations on pages 14 and 17 of this manual.
1. Turn the stove completely off and allow it to cool completely.
2. Remove the Stove Top and Stove Front. See instructions on page 14.
3. If the glass is broken, be sure to wear gloves and eye protection.
4. Unlatch the three glass frame latches by pulling forward on the latch finger tabs while lifting up. This will allow
the glass frame to tip slightly forward. The glass is loose in the frame, held in place only by friction from the gasket
so it is very important to support both the glass and the frame when handling. Place your thumbs on the outside
of the glass frame and wrap your fingers around the frame and onto the glass. Squeeze the frame and glass
while moving. Carefully lift the glass frame and glass up and off the stove. Set the glass and frame aside on a
padded surface. If the glass is broken, do this over spread out newspaper to catch all loose material. The outside
of the frame should be facing down to give access.
5. Carefully remove the old glass and gasket material. If the glass is broken, wear gloves and eye protection.
6. Be sure to remove any broken glass from the burner and logs.
7. Install the new glass gasket onto the glass panel following the instructions included with glass panel.
8. With the thin section of the glass gasket facing the inside of the glass frame, carefully press the new glass
panel/gasket assembly into the glass frame by first inserting the top edge under the two gasket retainers and
then pressing the sides and bottom edge into the frame.
9. Carefully pick up the glass and glass frame assembly by grasping the sides of the frame and using your
thumbs and fingers to hold the glass in place within the gasket and frame.
10. With the glass frame (and glass) at a slight angle (leaving room for your fingers between the frame and the
firebox) insert the bottom edge of the frame into the frame retainer located on the bottom front of the firebox.
Take care to center the frame from left to right. Once the bottom edge is in place, move your fingers out of the
way and press the top of the frame against the firebox while pushing down to be sure the frame is fully engaged
in the frame retainer. Hold the frame in place with one hand and engage the three glass frame latches by pulling
out and down while hooking them over the frame.
11. Replace the Stove Front and Stove Top. See instructions on page 18.
WARNING: Do not operate the appliance with the glass front removed, cracked or broken Replacement
of the glass should be done by a qualified service person.
WARNING: Use only replacement glass, part number 3-40-21001500 and glass gasket, part number
3-44-00539. Do not use substitute materials. Do not strike or slam the glass front
BATTERY REPLACEMENT
When the batteries need replacement, the remote handset shows a low battery indicator “BATT”. The Ignition
and Control Module will give three short beeps when the valve motor operates. The cooking burner Ignition
Module will stop sparking. See the instructions on pages 19 - 20 for details on changing batteries.
CLEANING THE GLASS
WARNING: Never clean the glass while it is hot. Do not use abrasive cleaners or cleaners containing
ammonia.
NOTE: A micro-fiber cleaning cloth and plain water is recommended by the glass manufacturer.
