page 23
DriveCore Install DA Series Operation Manual
Configuring the Inputs and Outputs
Adjusting Input Levels
The DCi DA amplifiers can use both analog and/or Dante inputs. Input levels can be adjusted from the Input Configuration panel, which can be accessed by double-clicking
a channel's
Input
icon and then clicking the
Input Configuration
button from the Source Routing panel (see
). This opens the Input Configuration panel,
where the amplifier input levels can be adjusted to accommodate different signal levels from the sources. The meters on this panel display both peak and rms levels. The
Gain Mode
setting (maximum analog input level for the amplifier) can also be set here, which will affect all analog input channels.
Figure 31:
Input Configuration panel
TIP:
To maximize the signal-to-noise ratio when using the analog inputs, select the
Gain Mode
setting that most closely matches the maximum output level of the source
device yet doesn't allow the inputs of the amplifier to clip.