page 20
DriveCore Install DA Series Operation Manual
Application Examples
Dual Mode Hi-Z (70Vrms/100Vrms) Mode
Typical input and output wiring, along with
software settings are shown in
and
. A 35Hz high pass filter is selected
automatically when the amplifier channel is in
Hi-Z or Bridged Hi-Z mode. Remember, DCi
amplifiers allow each channel Hi-Z or Low-Z mode
of operation to be selected independently, while
70Vrms/100Vrms selection is global.
DANTE: When connecting via Dante, two Dante-
equipped devices can be connected directly
together using the Primary Dante ports. If
connecting more than two Dante devices, the
Primary ports of each device should be connected
to a network switch (this is a referred to as a "star"
network topology).
100Mbps network switches and Category 5 cabling
can be used for smaller Dante networks where
smaller channel counts and/or lower sample rates
are used. For optimum performance and improved
reliability, a Gigabit network and Category 5e or
Category 6 cabling should be used. Visit the
Audinate website for more information.
To provide fault protection when using Dante,
connect the Secondary ports of all Dante devices to a secondary (separate) network switch. If any "primary" cable connections or the "primary" switch fail, the "secondary"
Dante network will automatically take over.
For further information on Dante, refer to
Figure 26:
Audio Architect amplifier mode settings
NOTE:
70Vrms/100Vrms is global, while Low-Z/Hi-Z is per output channel.
NOTE:
Always route the input and output wires in separate bundles.
WARNING:
Only connect to networks that remain inside the building.
4
3
2
1
SERIAL NUMBER
SERIAL NUMBER
BAR CODE
RESET
100 – 240V 50/60 Hz 1400W
CAUTION - TO REDUCE THE RISK OF ELECTRIC
SHOCK, GROUNDING OF THE CENTER PIN
OF THIS PLUG MUST BE MAINTAINED
MAC
ADDRESS
GPIO
ETHERNET
100Mb
ACT
OUT
+3.3V
IN
CLASS 2
WIRING
OUTPUT
WIRING
2
1
DUAL
DUAL
BRIDGE
DATA
PRESET
DANTE
PRIMARY
SECONDARY
Figure 25:
System wiring for 70Vrms/100Vrms operation
Summary of Contents for crown DriveCore Install DA Series
Page 59: ......
