Wiring and Device Connections
29
Instruction Manual - Enova DVX-325xHD/22xxHD All-in-One Presentation Switchers
AUDIO MENU Pushbutton
Press the AUDIO MENU pushbutton to access the audio options, displayed on the LCD display. There are three audio menus (AUDIO
OUTPUT, AUDIO INPUT, and MIC) and all are accessible by using this button. Multiple presses cycle through the various AUDIO
menus.
FIG. 19 displays the AUDIO MENU pushbutton.
FIG. 19
AUDIO MENU Pushbutton
The Audio menu enables you to see and adjust most parameters of the audio input and output signals.
Use the UP and DOWN navigational buttons to traverse the various parameters.
Use the LEFT and RIGHT navigational buttons to adjust the selected audio parameter.
Adjustments take effect immediately and are saved when you advance to another option or exit the menu. The menu exits
automatically after no user interaction on the front panel for 30 seconds.
See the
section on page 59 for a listing of all available options and instructions on how to change the settings.
Navigation Pushbuttons
The four directional navigation buttons (Left/Right/Up/Down) enable you to navigate through and adjust the configurable
parameters shown on the LCD display. The UP and DOWN navigation buttons are used to move between configurable parameters
within a menu. Pressing UP takes you to the previous configuration parameter. Pressing DOWN takes you to the next configuration
parameter. These buttons do not change the currently selected menu.
The LEFT and RIGHT navigation buttons are used to change the setting of the displayed parameter. If the parameter is read-only
the value cannot change. Pressing LEFT decreases the value displayed if the setting is numeric, or goes to the previously set item if
the setting is a set selection. Pressing RIGHT increases the value displayed if the setting is numeric, or goes to the next set item if
the setting is a set selection. These buttons do not change the currently selected menu.
FIG. 20 displays the navigation pushbuttons.
FIG. 20
Navigation Pushbuttons
STATUS Pushbutton
Press the STATUS pushbutton to access the STATUS menu on the LCD display.
FIG. 21 displays the STATUS pushbutton.
FIG. 21
STATUS Pushbutton
The STATUS menu enables you to see status information such as IP address and installed firmware versions as well as adjust LCD
and LED backlight intensity.
Use the UP and DOWN navigational buttons to traverse the various options.
Use the LEFT and RIGHT navigational buttons to adjust the selected LCD and LED backlight intensity (when selected).
Adjustments take effect immediately and are saved when you advance to another option or exit the menu. The menu exits
automatically after no user interaction on the front panel for 30 seconds.
See the
section on page 61 for a listing of all available options and instructions on how to change the settings.