Rear Panel Connections
11
ª
Tape Monitor Play/In:
Connect
these jacks to the Play/Out jacks of
an audio recorder.
‚
Tape Monitor Record/Out:
Connect these jacks to the Rec/In
jacks of an audio recorder.
NOTE:
When these jacks are con-
nected to a three-head recorder or
another device with off-head play-
back, it will be possible to monitor
the source being recorded.
⁄
Tape 2 Play/In:
Connect these
jacks to the PLAY/OUT jacks of a
second audio recorder.
Tape 2 Record/Out:
Connect
these jacks to the Rec/In jacks of a
second audio recorder.
‹
Main In:
These jacks are the input
to the HK3270’s power amplifier. Unless
an external power amplifier is used, the
jumper pins should remain connected
to the
Preamp Out
jacks
›
.
›
Preamp Out:
These jacks
proved an output for the left and
right channels to an optional exter-
nal amplifier. In normal operation,
unless an external power amplifier
is used, the jumper pins should
remain connected to the
Main In
jacks
‹
.
fi
Subwoofer Out:
Connect these
jacks to the line level input of a pow-
ered subwoofer. If an external sub-
woofer amplifier is used, connect this
jack to the subwoofer amplifier input.
fl
Speaker 1 Terminals:
Connect
these terminals to the appropriate
terminals on your speakers.
‡
Speaker 2 Terminals:
Connect
these terminals to the appropriate
terminals on your speakers.
°
Accessory Outlets:
These
outlets may be used to power low-
current draw devices such as CD
players or cassette decks. Note that
the power to these outlets will remain
on as long as the
Main Power
Switch
1
is pressed in. These outlets
will continue to be powered even
when the unit is in the Standby mode.
To remove power to these outlets, the
Main Power Switch
1
must be
placed in the OFF position.
NOTE:
The power consumption
of the devices plugged into these
outlets should not exceed 100 watts.
·
Power Cable:
Connect the AC
plug to a non-switched AC wall
output.
HK3270 "U" om (B) 2/5/99 10:40 AM Page 11