ENGLISH
22
Adjusting the current channel level
• Each time these buttons are pressed, the corresponding
channel is selected as follows:
�
REF 1, 2(or CAL)
�
FL
�
C
�
FR
�
�
<DTS or DD>
�
SW
�
SL
�
SR
�
< >: Only when the digital signals from Dolby Digital or DTS
program sources that include LFE signal are input, LFE level
is displayed.
• Depending on the speaker settings ("N (None or No)")
and surround mode, etc., some channels cannot be
selected.
• When all the speakers are switched off, only the Front Left
and Front Right channels can be selected.
• After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to
suit your tastes.
• You can adjust the current channel levels as desired. These adjusted levels are just memorized into user’s memory ("CAL"),
not into preset memory("REF 1", "REF 2").
• The LFE level can be adjusted within the range of -10~0
dB and other channel levels within the range of -15 ~ +15
dB.
• In general, we recommend the LFE level to be adjusted to
0 dB.(However, the recommended LFE level for some
early DTS software is -10 dB.) If the recommended levels
seem too high, lower the setting as necessary.
• Then the memory mode ("REF1", etc.) is displayed for
several seconds.
• When the memory mode or channel level disappears,
press this button again.
1.
Press the CHANNEL SELECT button.
2.
Select the desired channel.
3.
Adjust the level of the selected channel as desired.
4.
Repeat the above steps 2 and 3 to adjust each
channel level.
AVR-134 2008.12.1 10:31 AM 페이지 22
