- 19
8 | Function Test
Function Test
Before each use, verify that the rope is correctly installed and that the device is working properly. The CLUTCH must be properly
rigged prior to use. Always use a backup safety system when performing this test.
1) Move the Control Handle to the Stand By Position and give a quick pull on the anchor/load side of the rope. When rigged
correctly the CLUTCH will lock up.
(SBEVBMMZBQQMZBMPBEUPUIFEFWJDF SPQFUBVUIBOEMFJOTUBOECZQPTJUJPO8IJMFmSNMZHSJQQJOHUIFCSBLJOHTJEFPGUIF
rope, gradually move the Control Handle to Descent Position to allow rope through the device.
• Descent is possible = rope correctly installed.
• Descent is not possible = check the installation of the rope.
3) When the Control Handle is released, the CLUTCH should lock up and hold the rope.
4) Pull rope through the device as if using it to haul. Audible clicking sound should be noticeable.
WARNING: DANGER OF DEATH.
Do not allow anything to interfere with the operation of the device or its components
(Sheave, Control Handle, etc.). Any constraint on the device may negate the braking function.
2
3
1
4
Summary of Contents for CMC CLUTCH
