5
NATURAL GAS OR LIQUID PROPANE WITH NO KEY VALVE
1. Make sure gas is shut off.
2. Connect proper hose to gas supply.
3. Connect the other end of the hose to the brass elbow orifice holder
4. Connect the appropriate orifice. The bigger orifice hole is for NG.
5. Attach the pipe reducing fitting over the orifice.
6. Connect the pipe reducing fitting to the fire-wheel on the side with holes.
7. Finally, connect the plug that came with the fire-wheel to the other side. Note that the holes will be face
down to keep out water and any other debris from falling inside. This will not affect flame height.
LIGHTING INSTRUCTIONS
1.
STOP!
Read the
Gas Cylinder, Important Information and
Enclosures
sections before
attempting to light this appliance.
2. BEFORE LIGHTING: Smell all around the appliance area for gas. Be sure to smell next to the
floor of the firepit because some gas is heavier than air and will settle in the base of the firepit.
3. Light a match and place it just to the top and outside area of the Top Burner Plate.
4. Slowly turn the manual gas valve to the “OPEN” position. The firepit burner should ignite between
0 to 3 seconds.
INSTALLATION
LP
NG
