Page 16 of 19
B
la
z
e
_
O
p
_
M
a
n
u
a
l_
(2
0
1
2
-1
0
-1
2
).d
o
c
HARDT
Responsive, Reliable Solutions
7. Troubleshooting
DISCONNECT POWER TO THE ROTISSERIE BEFORE ANY MAINTENANCE,
SERVICE OR CLEANING IS PERFORMED.
ROTISSERIES EQUIPPED WITH CASTERS ARE SECURED IN PLACE USING A
RESTRAINING CABLE LOCATED ON THE RIGHT REAR UNDERSIDE OF THE
ROTISSERIE. THIS CABLE MUST BE DISCONNECTED PRIOR TO REMOVING THE
ROTISSERIE AND CAUTION MUST BE TAKEN TO ENSURE IT IS CONNECTED
ONCE THE ROTISSERIE HAS BEEN RETURNED TO ITS ORIGINAL POSITION.
THE ROTISSERIE IS HOT WHEN OPERATING. EXERCISE CAUTION WHEN
WORKING NEAR THE HOT ROTISSERIE.
WEAR APPROPRIATE PROTECTIVE CLOTHING.
7.1 Rotisserie does not Operate
SYMPTOM:
•
The rotisserie does not operate when the red main ON/OFF is
pulled out (i.e. drive does not turn, and no glow from igniter).
SOLUTION:
•
Check the rotisserie electrical power: If the rotisserie's lights are
off, check the circuit breaker on the back of the unit as shown in
Figure 7-1. If the circuit breaker is ‘OFF’ (tripped), return to 'ON'.
•
Verify that the door is fully closed. The door switch disables the
ignition system.
•
If this circuit breaker is ‘ON’, ensure that the power cord is plugged
into the wall and that there is power coming from the socket. If
power is available and the rotisserie still does not operate, contact
your local authorized service partner.
7.2 Safety Lockout
SYMPTOM:
•
If the red main ON/OFF switch is pulled out, the drive drum will rotate and the igniter will attempt to light the
burner. If there is no flame after six minutes, the rotisserie will go into Safety Lockout mode, an alarm will
sound and the red light on the panel will illuminate.
SOLUTION:
•
Turn the rotisserie off by pushing in the red main ON/OFF
switch.
•
Verify that the gas supply to the rotisserie and the main gas
valve are both open. Try starting the unit again by pulling the red
main ON/OFF switch out.
•
If the rotisserie goes into ‘safety lockout’ again. Turn the
rotisserie OFF.
•
If you are certain the rotisserie interior is sufficiently cool to
touch, use a soft towel to gently wipe the top of the burner and
carefully clean the flame sensor (Figure 7-2).
•
Try starting the rotisserie again. Pull out the main ON / OFF
switch.
If the rotisserie goes into safety lockout again turn the rotisserie OFF and
contact your local authorized Hardt service provider.
Figure 7-1: Circuit Breaker
Figure 7-2: Wipe Sensor & Burner
Circuit Breaker
Flame Sensor
Burner
