13
www.hardlifeutility.com
1. Insert the ø12mm steel rod (component code 10) into one duckbill nail (component code 9), and use an
electric hammer to insert the nail deep into the ground, as shown in Figure 8.
2. Fix the duckbill nail to the lower end of the arch tube using U bolts (component code 11). There are 6
duckbill nails.
3. Your carport assembly is complete.
NOTE:
Use duct tape to close the gaps in between the steel frame after installation of the carport, if required. You can
also use duct tape on some tube connections near the top of the frame to ensure that the roof cover doesn’t
tear from rubbing against sharp corners.
MAINTENANCE
• It is mandatory to tighten the roof fabric enough to avoid “hammocks” on the roof and re-tighten the
roof fabric regularly. This maintenance procedure is crucial as the roof fabric tends to be stiff in the cold
season (autumn and winter) and slack during summer. Hence, the roof fabric should ideally be re-tight-
ened before the next winter.
• Adjust the roof cover every month to ensure you always have a flat and tensioned roof cover.
• Inspect the carport regularly, and replace damaged components.
