17
3 - Description
Operating unit
Your sprayer will be equipped with operating unit accordingly to country specifi cations.
The mistblower can be equipped with following types of operating units: MC/2, CB/2, SV and CB.
BK/2
Manual operating unit with pressure equalisation. Optionally remote operated by cable
MC/2 operating unit
It has two section valves which control RH and LH sides. The section valves are remote controlled from the tractor cab by
via two bowden cables.
BS/2
Manual operating unit, placed near drivers position. Allows pressure regulation, section controls , and manometer
incorporated.
SV operating unit
It has 2 or 4 section valves. It uses solenoid valves for on/off of each section. The SV operating unit has no pressure
equalization device. Pressure regulation is done manually in the working zone.
SA operating unit
Remote operated solenoid sections valves with manual pressure regulation
CA operating unit
Remote operated solenoid sections with pressure equalisation device and manual pressure regulation
CB operating unit
Electrical remote pressure regulation, section valves by means of motor valves with pressure equalization device.
Filters
The pressure fi lters are located on the bumper next to the air outlet
nozzle. In the HLC circuit the fi lters are made of plastic and in the HPC
circuit they are made of brass.
All fi lters should be kept in good condition and cleaned regularly. Make
sure you to use correct combinations of fi lter and mesh size. The mesh
size should always be less than the average of the total fl ow from the
nozzles.
Powder mixer
This is used to rinse the fi lter basket in tank’s fi lling hole when adding
powdered products that do not dissolve properly or form lumps in
contact with the water in the tank.
After using the powder mixer it must be disengaged as it uses a large
amount of the available pump capacity..
