Hardi FORCE, Operator'S Manual

Page: 29 / 52

27 HARDI ® FORCE™ BOOM OPERATOR’S MANUAL
7.3 Boom Transport Adjustments
Adjustment of Folded Wings
With the center section level (parallel) to the trailer, the boom wings
should fold in to 1/2" from the vertical pads on the transport brackets
(Fig. 24). If necessary, adjust as follows:
1. Position the wings in
transport so that the inner
wings are resting against the
front transport bracket.
Note: Make sure that the
wings are safely
strapped and secured
to the front transport
bracket.
2. Loosen jam nut ( A )(Fig. 25)
on the cylinder eye.
3. Remove bolt ( B )(Fig. 25).
4. With the hydraulic controls,
make sure that the fold
cylinder rams are extended
out to the maximum.
5. Adjust the cylinder eye inward
or outward until bolt ( B )(Fig. 25)
can be replaced without force.
6. After proper adjustment, install
bolt ( B )(Fig. 25) and tighten jam
nut ( A )(Fig. 25) on the cylinder
eye.
7. Repeat steps on the opposite
side.
Transport Brackets, Height
Settings
The front transport brackets can
be set in different positions to have
different transport heights for suitable clearance above various tractor
cabins.
Fig. 24
A
B
Fig. 25