4 - Sprayer setup
4.3
DANGER! ROTATING TRANSMISSION SHAFTS WITHOUT PROTECTION GUARDS ARE FATAL.
Swivel type Ø33 (A)
No
Yes
Swivel type Ø36 (A)
Yes
No
Hitch Ø50 (ISO 5692) (B)
Yes
Yes
High hitch (C)
Yes
Yes
Drawbar extensions
CM 2200/2800
CM 3200/4200
1. Always STOP ENGINE before attaching the transmission shaft to tractor P.T.O. - most tractor P.T.O. shafts can be rotated
by hand to facilitate spline alignment, when engine is stopped.
2. When attaching the shaft, make sure that the snap lock is FULLY ENGAGED - push and pull shaft until it locks.
3. Always keep protection guards and chains intact and make sure that it covers all rotating parts, including CV-joints at
each end of the shaft. Do not use without protection guard.
4. Do not touch or stand on the transmission shaft when it is rotating - safety distance: 1.5 meter.
5. Prevent protection guards from rotating by attaching the chains allowing sufficient slack for turns.
6. Make sure that protection guards around tractor P.T.O. and implement shaft are intact.
7. Always STOP ENGINE and remove the ignition key before carrying out maintenance or repairs to the transmission shaft
or implement.
The drawbar extension piece is inserted into the opening of the
drawbar, fastened by two main bolts through the two holes (A) and
secured by two linch pins.
Following drawbar extensions are available. The drawbar extensions
are available - steering or fixed - for both high and low tractor hitch
points. Each drawbar is available in a long or a short version, except
high hitch.
Transmission shaft - Operator’s safety
Drawbars - Mounting the drawbar extension
Mechanical connections
