HARD GEAR SGB16500VSa, Instruction Manual

Page: 15 / 36

- 14 -
AC 220V
ENGINE SW. PILOT
START
OFF
O N
ON
OFF
6. OPERATION
1. STARTING THE ENGINE (Refer to OPERATOR’S MANUAL for engine.)
1) Make sure that disconnect all electrical
loads from panel receptacles.
The generator may be hard to start if a
load is connected.
2) Turn the fuel valve to the “ON” position.
3) If you want to start operate the choke manually, move the choke knob to the
“CLOSED” position.
4) Start the engine
With the electric starter:
Turn the engine key switch to the
“START” position and hold it there
until the engine starts.
Do not use the electric starter for more than 5 seconds at the time.
If the engine fails to start, release the switch and wait 10 seconds
before operating the starter again.
OPEN POSITION CLOSED POSITION
ON
OFF
START