Page 2
For technical questions, please call 1-888-866-5797.
Item 63797
IMPORTANT SAFETY INFORMATION
1. Disconnect welder power and discharge
electrode to ground before installing.
2. Install only according to these instructions.
Improper installation can create hazards.
3. Wear ANSI-approved safety goggles and
heavy-duty work gloves during installation.
4. Keep installation area clean and well lit.
5. Keep bystanders out of the area during installation.
6. Do not install when tired or when under the
influence of alcohol, drugs or medication.
7. This product is not a toy. Do not allow
children to play with or near this item.
8. Use as intended only.
9. Inspect before installing; do not use
if parts are loose or damaged.
Installation Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
before set up or use of this product.
1. Disconnect welder power supply and
discharge electrode to ground.
2. Disconnect MIG Gun Cable from welder.
3. Remove the Nozzle and Tip from
the end of the MIG Gun.
4. Lay the MIG Gun Cable straight on a flat surface.
5. Remove small Set Screw in the
side of the MIG Connector.
6. Grab the plug at the end of the old Liner
and slide it out of the MIG Gun Cable.
7. Wear ANSI-approved safety goggles and a dust
mask. Then, blow compressed air through the
MIG Connector to clean out the MIG Gun Cable.
