Page 3
For technical questions, please call 1-888-866-5797.
Item 63797
8. Lay out the old and new Liners flat next to each
other. Line up the plug ends of the Liners with one
another. Trim off the plain end of the new Liner
even with the other liner. Make sure the end of the
new Liner remains open while cutting and remove
any Liner pieces that are left hanging after cutting.
9. Insert the new Liner into the end of the MIG
Connector until it is fully inserted. Make sure
the O-ring seats properly into the Connector.
10. Hold the new Liner in place in the MIG Connector
while securing it in place using the Set
Screw on the side of the MIG Connector.
11. Reassemble the MIG Gun and
connect it to the Welder.
