Page 4
For technical questions, please call 1-888-866-5797.
Item 64983
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at
the beginning of this manual before set up or use of this product.
This Gear Puller will deliver up to 5 tons (10,000 lb.) of pulling force.
DO NOT use tool on any work piece which cannot withstand the specified amount of pressure.
1. Open Return Valve (7) to fully retract
Piston (2). Close the Return Valve by
turning it clockwise until hand tight. Do not
overtighten, as this will damage the seal.
2. Place the Jaws (1) around (or in) the item to
be pulled. Be sure they will have a firm grip.
3. While holding the Jaws in place, rotate the
Puller Unit on the Puller Sleeve (6), until the
end of the Piston (2) contacts the work piece.
4. Pump the Handle (11) up and down
to force the Piston down, causing
the Jaws to pull upward.
5. Continue pumping the Handle, being
sure the Jaws stay in place on the object
and the object is not being damaged.
6. In most cases, a certain amount of pressure
will build up, and the Gear Puller will
suddenly loosen and release. Support the
Gear Puller to prevent it from falling.
7. When finished, open the Return Valve (7)
by turning it 1 turn counterclockwise
(do not remove), and remove the
Gear Puller from the workpiece.
8. To prevent accidents, clean, then
store the Gear Puller in its case,
indoors out of children’s reach.
