7.
PROPER BATTERY CARE:
Battery leakage may occur under extreme usage or
temperature conditions. If battery fluid comes in contact with skin, wash with
soap and water and rinse with lemon juice and vinegar. If the fluid comes into
contact with the eyes, flush with water for several minutes and contact a doctor
immediately. Never burn batteries, as they can explode in a fire. Do not charge
a Cordless Screwdriver with a leaking battery. Contact local solid waste
authorities for instructions on correct disposal or recycling of the batteries.
8.
WARNING:
People with pacemakers should consult their physician(s) before
using this product. Operation of electrical equipment in close proximity to a heart
pacemaker could cause interference or failure of the pacemaker.
UNPACKING
When unpacking, check to make sure all the parts shown on the
Parts List on page 8
are
included. If any parts are missing or broken, please call Harbor Freight Tools at the
number shown on the cover of this manual as soon as possible.
OPERATING INSTRUCTIONS
NOTE:
For additional references to the parts listed below, refer to the
Assembly
Diagram
on page 9.
To Adjust The Handle:
1.
The Handle Assembly (parts #6, #7, #8, #9) of the Cordless Screwdriver may be
angled for ease of control, or easier access to the workpiece. The Handle
Assembly is fixed in position by a Locking Switch (part #12) To adjust the Handle
Assembly, push and hold the Locking Switch forward while at the same time
moving the Handle to the desired position. Then, release the Locking Switch.
The Handle will now be locked in the desired position.
(See Figure C.)
FIGURE B
SKU 47953
PAGE 5
EXTENSION CORD AWG RATING CHART - 120 VOLT
