SKU 91771
For technical questions, please call 1-800-444-3353
Using the hand cranked dynamo to charge the internal battery.
You can charge the internal
battery by hand cranking the built-in
charger. Briskly turn the crank handle in
a clockwise direction to charge the
internal battery. NOTE: Do not crank the
charger for more than 15 minutes at a
time. After cranking for 15 minutes, stop
and let the charger cool down for at least
5 minutes before resuming cranking.
The hand cranked dynamo is a
low power charging alternative. It is most
effective for charging the battery for use
with the blinking light. One minute of
rapid cranking will power the blinking light
for approximately 20 minutes.
Replacing the Rechargeable Battery & Bulb
The internal rechargeable battery should only be replaced by a qualified
service technician. Replacement directions as follows:
1)
Open the battery compartment at the bottom of the lantern.
2)
Remove the existing rechargeable battery. You will have to cut the wires
connecting the battery to the
lantern.
3)
Reconnect the wires on the
replacement battery, matching
the polarity of the battery by
matching the wire colors.
4)
Place the new battery in the
battery compartment, and replace
the cover. Always dispose of
batteries properly. Contact your
local hazardous Waste Authority
for proper disposal guidelines.
5)
Install the new bulb by screwing it clockwise into the socket until finger tight.
6)
Replace the light bulb cover by pressing it back into place.
Page 7
Rechargeable Battery
Compartment
Flash Light Bulb
Crank Handle
