10.
The Barbeque is designed for outdoor use only.
Do not use this product in a trailer, tent,
house, garage, or any enclosed area.
11.
Always use the Barbeque in an open area away from buildings, dry leaves or brush.
Be
aware of wind blown sparks.
12.
Avoid high pedestrian traffic areas.
Do not allow people or pets to conduct any activity near
the Barbeque while the unit is in use, or following its use. The Barbeque is hot during use, and
will remain hot for a period of time after use.
13.
Never use gasoline, kerosene, or other highly volatile fluids as a starter as they can
explode.
14.
Make certain all parts of the Barbeque are firmly in place and that it is positioned on a
flat, level, fire retardant surface.
15.
Never leave the Barbeque unattended while lit.
16
. Do not clean the Barbeque with cleaners that are combustible or corrosive.
17.
Keep children away.
Children must never be allowed in the work area. Do not let them handle
machines, tools, or extension cords.
Warning:
The warnings, cautions, and instructions discussed in this instruction manual cannot
cover all possible conditions and situations that may occur. It must be understood by
the operator that common sense and caution are factors which cannot be built into
this product, but must be
supplied by the operator.
Assembly
Your Fire Pit/Barbeque will require complete assembly prior to use. It is important that you read the
entire manual to become familiar with the product BEFORE you use the Fire Pit/Barbeque. Before
assembling the Fire Pit/Barbeque be sure that you have all parts described in the Parts List and
Assemby Diagram located on the last pages of this manual.
Step 1)
Set the Door Frame (F) onto the Base (A). Place a Spring Washer (W1) on a Round
Head Phillips Bolt (S1). Slide one, Round Head Phillips Bolt (S1) down through the
Door Frame (F) and through the Base (A). Thread (but do not tighten) on one Nut
(N1) to hold Base (A) and Door Frame (F) together. Repeat steps for the other side
of Door Frame (F). Now tighten both Nuts (N1) to securely hold Door Frame and
Base together.
Step 2)
Set the Back Panel (H) onto the Base (A) opposite the Door Frame (F). Place a
Spring Washer (W1) on a Flat Head Phillips Bolt (S1). Slide one, Round Head
Phillips Bolt (S1) down through the Back Panel (H) and through the Base (A). Thread
(but do not tighten) on one Nut (N1) to hold Base (A) and Back Panel (H) together.
Repeat steps for the other side of Back Panel (H). Now tighten both Nuts (N1) to
securely hold Back Panel and Base together.
Step 3)
On one side, slide one Side Panel (G) down between the Back Panel (H) and Door
Frame (F) until the Side Panel (G) rest in the fixed tabs at the bottom of the Door
Frame and Back Panel. On one side, align the holes in the Door Frame (F) and Side
Panel (G) and screw in (do not tighten) one Flat Head Phillips Bolt (S2). On the same
side, now align the holes in the Back Panel (H) and Side Panel (G) and screw in one
Flat Head Phillips Bolt (S2). Now tighten both Flat Head Phillips Bolts with Cap Nuts
(N2) to securely hold the Side Panel to the Door Frame and Back Panel. Repeat the
steps above to install a Side Panel on the other side.
#90516
Page 3
Rev 09/03
REV 11/03
90516 BBQ.p65
11/4/03, 7:57 AM
3