Page 6
For technical questions, please call 1-888-866-5797.
Item 57998
Maintenance
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Unplug the Power Pack from its electrical outlet before performing any procedure in this section.
1.
CLEAN PERIODICALLY
with a damp towel.
Do not clean with chemicals, solvents or harsh
abrasives. Do not put too much pressure
on the display or buttons while cleaning.
2.
WARNING! TO PREVENT SERIOUS INJURY: If
the plug or the supply cord is damaged, it must
be replaced only by a qualified service technician.
Troubleshooting
Problem
Possible Causes
Probable Solutions
Lights will not turn on
1. No power.
2. Bad connection at Power Pack.
3. Short in landscape wire.
4. Power Pack overloaded.
5. Circuit overloaded.
1. Check that Power Pack is connected
to 120VAC GFCI outlet.
2. Check for loose connection
at screw terminal.
3. Replace shorted wire with
16/2 16AWG/2-Conductor Low
Voltage Landscape wire.
4. Remove some lights or replace
with wire with heavier gauge.
5. Check circuit breakeer.
Only some Lights work
1. Bad connection at Light.
2. Faulty Light.
1. Check that connector pins have
pierced the landscape wire wires.
2. Replace Light.
Lights do not turn off at dawn
Dirty Photo Cell
Use soft cloth to clean photo cell.
Follow all safety precautions whenever diagnosing or servicing
the tool. Disconnect power supply before service.
