Page 5
For technical questions, please call 1-888-866-5797.
Item 57998
Installation
WARNING! TO PREVENT SERIOUS INJURY:
Verify that installation surface has no hidden
utility lines before installing light fixtures.
1. Place Power Pack close to GFCI outlet. It
must receive maximum sunlight in order
for photo sensor to work properly.
2. Lay Power Pack on its back on a sturdy surface.
Do not plug in Power Pack.
3.
Connect Wires to Power Pack
a. Split conductors 2
″
, strip 3/4
″
of
insulation, twist strands together.
b. Loosen screws. Insert each conductor
under one screw. Screw connections must
be tight. Do not mix solid and stranded
type wires under one screw. Make sure
insulation clears Pressure Plate.
4.
Mount Power Pack
WARNING! TO PREVENT SERIOUS INJURY:
Verify that installation surface has no hidden
utility lines before drilling or driving screws.
a. Using included template, mark
and drill mounting holes.
b. Insert two included anchors into the holes
and two included screws into the anchors
leaving about 1/4
″
of threads exposed.
c. Place large center of keyholes on back of Power
Pack over screw heads and pull down gently to
lock screws into keyholes.
Do not plug in Power Pack.
5.
Install Light Fixtures
a. Lay out light fixtures in desired locations.
The first light fixture must be installed
at least 10 feet from Power Pack.
b. Lay out Landscape Wire from Power Pack
along path of light fixtures.
c. Install light fixtures, then connect to wire
according to light fixture’s instructions.
d. Bury wire no deeper than 6".
6. Plug in Power Cord.
Do not use
an extension cord.
7. Press Up/Down buttons to scroll through menu.
a.
A
= Auto - Dusk to dawn.
b.
1 -9
= Hours on after dusk.
c.
O =
Manual - On until manually turned off.
