Step 4)
Lay Back Panel (B) up against the back of the Top Panel (A) and secure it in place
with two Bolts (H), Washers (N) and Nuts (P)-see Figure 1.
Back Panel (B)
Bolt-Washer-Nut
Top Panel (A)
Figure 1-Top to Back
Step 5)
Place one Leg (G) over each corner of the Workbench assembled thus far in steps 1
through 4. Insert a Bolt (H) through the hole in the center of the Leg (G) and through
the Back Panel (B). Slide on Washers (N) and tighten on Nuts (P)-see Figure 1.
Insert a second Bolt (H) into the hole on the other side, and secure with Washer (N)
and Nut (M). Repeat for second rear Leg (G). Repeat for front two (2) Legs (G).
Step 6)
Locate the Door with Lock and Key (F). Slide the pin on top of the Door (F) up into
the hole in the lip of the Top Panel (A). Slide the Bottom Panel (O) so that the pin on
the bottom of the Door (F) slides into the bottom hole.
Step 7)
Attach the Bottom Panel (O) to the Side Panels (C,E) by inserting Bolt down through
the lip of the Side Panel, then down through the Bottom Panel (O)-see Figure 2.
Attach the Back Panel (B) up against the back of the Bottom Panel (O) and secure it
in place with two Bolts (H), Washers (N) and Nuts (P)-see Figure 1. Attach the
Support Panel (D) to the Bottom Panel (O) and secure with same hardware.
Leg (G)
Bottom Panel (O)
Side Panel (E)
Figure 2
Step 8)
Set the lip of the Drawer-Backing on top of the Drawer-Base. Attach the Drawer
Backing (R) to the Drawer Base (K) with three (3) Bolts, then slide on Washers (N)
and secure with Nuts (P).
#47878
Page 4
Bolt (H) down through lip
