Item 40939
For technical questions, please call 1-888-866-5797.
Page 4
15. DO NOT OPERATE THIS MACHINE WHILE UNDER THE INFLUENCE OF
ALCOHOL, DRUGS, OR PRESCRIPTION MEDICINES.
16. CHECK FOR DAMAGED PARTS. Before using any tool, any part that appears
damaged should be carefully checked to determine that it will operate properly and
perform its intended function. Check for alignment and binding of moving parts,
any broken parts or mounting fixtures, and any other condition that may affect
proper operation. Any part that is damaged should be properly repaired or replaced
by a qualified technician. Do not use the tool if any switch does not turn on and off
properly.
17. REPLACEMENT PARTS AND ACCESSORIES. When servicing, use only identical
replacement parts intended for use with this tool. Replacement parts are available
from Harbor Freight Tools. Use of any other parts will void the warranty.
18. PEOPLE WITH PACEMAKERS should consult their physician(s) before use.
Electromagnetic fields in close proximity to heart pacemaker could cause
pacemaker interference or pacemaker failure.
Special Warnings when using this Vertical Mill
Using this Vertical Mill may create special hazards.
Take particular care to safeguard yourself and those around you.
1.
Electrical Safety.
Never operate any tool if there is an electrical hazard. Never
operate an electrical tool in wet conditions. Never operate a tool with an improper
electrical cord or extension cord. Never operate an electrical tool unless you are
plugged into a properly grounded outlet, which supplies 220 Volts at 60 Hz. We
recommend you use a circuit which is protected by an appropriate circuit breaker.
2.
Ejected Material
. Use safe practices to avoid injury from ejected material.
Because the Milling tools and workpieces turn at high speed, there is a danger of
being injured by materials that may be ejected. Always wear ANSI-certified eye
protection. Never attempt to machine any if it is not adequately held. Always stand
to one side of the plane in which the materials are spinning, to avoid being hit if an
is ejected. Never allow bystanders to be in the proximity of the Vertical Mill while in
operation.
3.
Entanglement.
Use extreme caution to prevent loose materials from being caught
in the machine. Never operate this mill with loose clothing, long hair, jewelry,
or other items which may become caught in the tools or workpieces. In case of
entanglement, press the OFF switch immediately.
NOTICE:
No list of warnings can be all inclusive. The operator must supply common
sense, and operate this tool in a safe manner.
