FINAL INSTALLATION
13
DANGER:
To reduce the risk of serious bodily
injury,
DO NOT use power tools to assemble the
blades (H). If screws are overtightened, blades (H)
may crack and break.
Insert the blade (H) through the slot on the band of
the motor housing (D). Align holes in blade (H) with
holes in plate on underside of motor. Attach the
blade (H) with blade screws (AA) and rubber blade
washers (BB). Then, tighten each blade screw (AA),
starting with the one in the middle. Repeat for
remaining blades (H).
2.
3
2
D
H
BB
AA
AA
Blade Screw x 15
Rubber Blade Washer x 15
BB
Hardware Used
Band
3. Remove one motor plate screw (E) from posts on
motor plate preassembled on the underside of the
motor housing (D) and partially loosen the other
two motor plate screws (E). Connect male plug
from motor housing (D) to female plug from switch
housing (F), matching up the colors on the plugs
for correct fit. Make sure plugs connect tightly.
Carefully arrange wires inside switch housing (F).
Align slotted holes in switch housing (F) with
loosened motor plate screws (E), allowing male
and female plug connections to come through
hole in switch housing (F). Twist switch housing
(F) to lock. Re-insert the motor plate screw (E)
that was removed and securely tighten all three
motor plate screws (E).
3
IE
IE
IE
F
D
Motor
Plate
Male Plug
Female
Plug
