1. Lift the motor body (B) onto the mounting bracket (A),
making sure not to break away any wire connections,
and allow the four threaded rods from the mounting
bracket (A) to insert into rubber grommets on the
motor bracket from the motor body (B). Attach the
hanger bracket to mounting bracket (A) using the
metal washers (N) and hex nuts (M) removed
previously. Tighten the hex nuts with a wrench (not
included).
2. Raise the motor housing (D) up, align the four dot
labels on the motor housing (D) with the mounting
bracket (A), place the mounting bracket (A) onto the
recesses on the motor housing (D) properly, then
rotate the motor housing (D) clockwise until the
mounting bracket (A) slide into the slot hole inside the
motor housing (D).
9
FINAL INSTALLATION INSTRUCTIONS
Motor Bracket
Recesses
Recesses
dot label
A
A
A
D
B
N
M
1
1
2
3. Position blade iron (E) under blade (F). Secure them
with three blade screws (BB). Do not tighten blade
screws (BB) until three are in place. Then, tighten
each blade screw (BB) starting with the center blade
screw (BB). Repeat for all blade assemblies.
Hardware Used
x 15
BB
Blade Screw
3
BB
F
E
