WIRING
13
1. Lift canopy (B) to mounting bracket (C) and
align slotted holes in canopy (B) with canopy
mounting screws (L) that were loosened in Step
4A of "Initial Installation" section on page 7.
Twist canopy (B) to lock. Re-insert the two
canopy mounting screws (L) that were removed
in the step mentioned above. Tighten all canopy
mounting screws (L) securely. (Fig. 1)
1
1
2
3
Dimmer
Switch
Speed
Switch
For illustrative purposes only
--
not
intended to cover all types of controls
IMPORTANT
: Using a full range dimmer switch (not
included) to control fan speed will cause a loud
humming noise from fan. To reduce the risk of fire
or electrical shock, do NOT use a full range dimmer
switch to control fan speed. (Fig. 3)
3.
3
FINAL INSTALLATION
L
A
B
Wrap electrical tape (not included) around each
individual wire connector (CC) down to the wire as
shown in Fig. 2.
WARNING
: Make sure no bare wire or wire
strands are visible after making connections. Place
green and white connections on opposite side of
box from the black and blue (if applicable)
connections.
Turn spliced/taped wires upward and gently push
wires and wire connectors (CC) into outlet box.
E3 Wire Connector x4
2.
Hardware Used
2
CC
CC
CC
CC