14
FINAL INSTALLATION
Gently feed molex wires (one at a time) from light kit
fitter (G) through center hole in switch housing (R).
Screw switch housing (R) onto threaded rod on light
kit fitter (G) followed by lock washer (EE) and hex nut
(DD). Tighten hex nut (DD) over lock washer (EE) for
a secure fit.
Then, connect WHITE molex wire from light kit fitter
(G) to WHITE molex wire from switch housing (R).
Connect BLACK molex wire from light kit fitter (G) to
BLUE molex wire from switch housing (R). Make sure
that molex connections snap together securely.
Lowes.com/harborbreeze
Locate motor screws (K) and lock washers (L)
previously removed (Step 5, page 7).
Insert two motor screws (K) along with lock washers
(L) through one blade arm (H) to attach blade arm (H)
to motor housing (D). Tighten motor screws (K)
securely. Repeat with remaining blade arms (H),
making sure to completely secure each blade arm (H)
before proceeding with the next.
3.
4.
If you wish to use the fan WITH the light kit
,
remove three fitter plate screws (E) from fitter plate
on underside of motor housing (D). Push center cap
out of switch housing (R) with a screwdriver.
Continue to Step 5.
If you do NOT wish to use the light kit
, proceed to
Step 10, page 16.
4
H
K
L
Center
Cap
R
E
D
Hex Nut x 1
Hardware Used
Lock Washer x 1
DD
EE
5.
3
D
J
Molex
Connections
5
R
G
DD
EE
G
R
DD
EE
