3. Check existing outlet box (not included) to ensure it is
securely fastened to at least two points in a structural
ceiling member and can support the full weight of the
fan. Once verified, install mounting bracket (A) to the
outlet box using the screws and washers provided
with the outlet box.
4. Remove the hairpin clip (O) and clevis pin (N) from
the coupling (F) preassembled on motor housing (G).
Retain for later use.
Loosen the two coupling screws (P) preassembled in
coupling (F), but do not remove them.
1. Place downrod assembly (D) through canopy (B),
canopy cover (C) and coupling cover (E).
Note:
If using the angle mount, make sure open end of
mounting bracket (A) is installed facing the higher point
of the ceiling.
3
Open End
A
A
DANGER:
A loose outlet box can cause the fan to
wobble and increase the fan's potential to fall, which
could result in serious injury or death.
7
Lowes.com/harborbreeze
INITIAL INSTRUCTIONS
STANDARD/ANGLE-MOUNTING INSTRUCTIONS
C
B
D
E
1
O
P
G
F
N
N
P
4
O
F
Note:
Make sure to keep loose hardware separate to
avoid confusion during installation.
For
STANDARD/ANGLE-MOUNTING INSTRUCTIONS,
proceed to Step 1 below. For
FLUSHMOUNT
INSTRUCTIONS
, skip to page 9.
