FAN MOUNTING
Depending on the length of downrod you use,
you may need to cut the lead wires back to
simplify the wiring. If you decide to cut back the
lead wires, it is suggested you do so in the
following manner:
Take the lead wires and make sure you have
pulled them all the way through the top of the
downrod (A). Start at the TOP of the downrod (A)
and measure 8 in. of lead wire, and then cut the
excess wire off with wire cutters (not included).
IMPORTANT:
Do
NOT
cut safety cable (M).
NOTE:
If you do
not
cut back the lead wires,
Steps 4 and 5 are not necessary and you may
proceed to Step 6 instead
.
4.
2. Insert downrod (A) through canopy (B), canopy
cover (H) and yoke cover (L). [
NOTE:
Canopy
cover (H) must be turned with the shiny side
toward
the motor assembly (D).] Thread wires
and safety cable (M) from motor assembly (D)
through downrod (A).
Tip:
Apply a small piece of electrical tape (not
included) to the ends of the wires before
threading them through the downrod (A).
3.
4
A
8
Lowes.com/harborbreeze
Set
Screw
F
A
E
3
D
2
A
B
L
H
L
H
Slip downrod (A) into yoke at top of motor
assembly (D), align holes and re-install pin (E)
and clip (F). Tighten downrod (A) set screws
and then tighten nuts. Slide yoke cover (L) down
until it rests on top of motor assembly (D).
M
M
