11
FINAL INSTALLATION
4. Feed the single-pin connector through center hole in
light pan. Align the two keyhole slots in the light pan (G)
with the loosened fitter plate screws (F). Place the light
pan (G) over the two screws and turn the light pan (G)
clockwise. Then tighten the two fitter plate screws (F).
Re-install the fitter plate screw (F) that was removed in
the previous step and tighten firmly.
5. Remove one and loosen the other two light pan screws
(H) from the underside of the light pan (G). Connect
the single-pin connector from the fitter plate (E) to the
single-pin connector from the light kit (I) -- blue to black
and white to white. Align the keyhole slots in the light
kit (I) with the loosened screws in the light pan (G).
Turn light kit (I) clockwise and replace the previously
removed light pan screw (H). Tighten all screws.
6. Attach the glass bowl (J) to the light kit (I) by twisting
the glass bowl (J) tightly in a clockwise direction until it
is secure.
CAUTION:
Avoid cross-threading the glass during
installation. Improper installation could cause the glass
bowl (J) to be difficult to remove or fall, which could
cause serious injury.
4
G
H
I
Single-pin
Connector
5
I
J
6
F
G
E
