10
FINAL INSTALLATION
1.
Remove one of the three fitter plate screws (F)
preassembled to the fitter plate (E) from the round hole
and loosen the other two but do not remove. Then,
turn the orange shipping block counterclockwise and
remove. Discard the shipping block.
2. Slide the canopy (C) over the mounting bracket (A),
aligning the slotted holes in the canopy (C) with the
previously loosened mounting bracket screws (B) in the
mounting bracket (A). Twist the canopy (C) clockwise
to lock. Then re-insert the mounting bracket screws (B)
(Step 4, page 8) and securely tighten all screws.
3.
Insert blade (K) through slot in the side of the motor
assembly (D). Align the holes of one blade (K) with
three blade screw holes in underside of the motor
assembly (D). Secure blade (K) with three blade
screws (BB) and blade washers (CC).
Repeat for the remaining blades (K).
Hardware Used
BB
Blade Screw
x 9
CC
Blade Washer
x 9
1
2
D
B
F
E
A
C
CC
BB
3
Shipping Block
K
